The safety group diagram of the storage water heater.

[zihadhosenjm40]

A special compression fitting for a water pipe is connected to the same tee. In case of excess pressure, some of the water from the storage tank will be discharged into the sewer system through it.

This set of devices prevents dangerous emptying of the device's capacity and removes excess water if the pressure inside exceeds the norm

After installing the device, it is imperative to ensure that the pressure valve hole remains open, otherwise the device will simply not work.

All threaded connections should be sealed and hermetically sealed. Experts recommend allowing at least four hours for the sealant to dry.

The photo clearly shows and labels the elements of the storage water heater safety group. When installing the device, it is important to strictly follow the sequence of their connection

To connect the device to the cold water riser, you can use steel, copper, plastic or metal-plastic pipes. When installing it yourself, plastic pipes are most often used, since soldering them is relatively easy.

Some use flexible hoses for these purposes, but this solution does not justify itself. As practice has shown, such elements wear out quickly.

The individual elements of the storage water heater russia mobile database group are connected using threads. In accordance with the standards, these places should be sealed and treated with a sealant

It is clear that before cutting in the pipes, the hot and cold water coming into the apartment should be shut off. A shut-off valve should be installed between the cold water riser and the heater so that the water coming to the device can be turned off if necessary. All connections are carefully sealed.

Now you need to connect another pipe that will connect the heater to the hot water supply system in the apartment. In this section, you will need another shut-off valve: between the hot water riser and the heater.

This valve should always be closed so that heated water from the boiler does not get into the common hot riser of the house. Again, you need to ensure that all connections are sealed and tight.

The shut-off valve for cold water between the heating device and the risers must be installed in such a way that when closed it does not interfere with the flow of water to other consumers, cutting off only the heater.

And the connection to the hot water supply system must be done in such a way that, if necessary, it would be possible to restore the flow of hot water from the common riser to the system in the apartment.