This option is used for roofs with a small lathing pitch.

[zihadhosenjm40]

Important:
With this method of fastening, the joints between the board and the roof must be reinforced to prevent it from being torn out under the load of snow.


First, the brackets are attached to the roof structure.
The edge of the gutter closest to the roof is bc data malaysia under the support hook and lowered into its receiving socket, the clamping strip is bent back and the opposite edge is fixed.
The height difference is achieved by bending the bracket at the calculated location.
As the intermediate brackets move away from the end bracket, the distance between the end of the support part and the bending point should be reduced.
This is an option for roofs with a large batten pitch. The bend lines of the extensions should be at the same distance. The bend point is located no closer than 1 cm from the point where the bracket clamp plate is fixed or from the end point of the slot in the extension.

How to ensure the optimal position of drainage elements relative to the roof
The roof overhang is located on the gutter at a distance of 30–50% of its diameter.
The gap that must be maintained between the support, its upper part and the roof extension line is 25-30 mm. It is provided by bending the final metal bracket (extension) or moving the plastic one.
How to ensure resistance to deformation under vertical load
The pitch of the gutter brackets should not be more than 600 mm.
The funnel must be secured at two points (respectively, two extensions/supports).
The gutter connector is secured at one point (respectively, extension/support).
The distance between the end part of the corner element and the nearest bracket is up to 150 mm.
The distance between the plug and the nearest bracket is no more than 250 mm.